UNIX Power Tools

UNIX Power ToolsSearch this book
Previous: 33.6 Change Many Files by Editing Just One Chapter 33
Batch Editing
Next: 33.8 Batch Editing Gotcha: Editors Bomb on Big Files
 

33.7 ed/ex Batch Edits: Avoid Errors When No Match

Q: My Bourne shell script (44.1) calls ed to edit a set of files:

Q:
= 

for 

<< 
\ 




site=something
cmty=somethingelse
for i in file1 file2 file3
do
   ed $i << end
   1,\$s/pat1/$site/g
   1,\$s/pat2/$cmty/g
   w
   q
end
done

Q: It works fine except when one of the files does not contain pat1. ed doesn't update that file, even though it could have matched pat2. The other files are edited as they should be.

A: On an error - including "no matches" - ed attempts to discard any unread commands. If you are running ed "by hand" this has no effect, but if its input is from a file, this makes EOF -d-of-file) the next thing it sees. You could remove the q command and you would see the same behavior, as ed automatically quits at end-of-file.

There is a simple workaround. Unlike the s command, the global command g does not report an error if no lines match. Thus:

ed - $i << end
g/pat1/s//$site/g
g/pat2/s//$cmty/g
w
end

The - (dash) flag suppresses the two numbers that ed normally prints when reading and writing files. These are the number of characters in the file, and are usually irrelevant. [As Chris explained, the q in the original script isn't needed. -JP ]

- CT in comp.unix.questions on Usenet, 16 May 1989


Previous: 33.6 Change Many Files by Editing Just One UNIX Power ToolsNext: 33.8 Batch Editing Gotcha: Editors Bomb on Big Files
33.6 Change Many Files by Editing Just One Book Index33.8 Batch Editing Gotcha: Editors Bomb on Big Files

The UNIX CD Bookshelf NavigationThe UNIX CD BookshelfUNIX Power ToolsUNIX in a NutshellLearning the vi Editorsed & awkLearning the Korn ShellLearning the UNIX Operating System


Banner.Novgorod.Ru